Some Technological Properties of Sawn Board Eucalyptus Camaldulensis Denh.Grown In Askikalak
Article Sidebar
Main Article Content
Abstract
This study deals with wood density and static bending boards property of Eucalyptus camaldulensis Den. It was conducted using standardized, defect-free test specimens. Boards of air drying showed lowest value (749.117 kg/cm²) of static bending when compared with kiln (812.267kg/cm²) and solar (815.267kg/cm²) drying respectively, whereas, the quarter sawing boards recorded the lowest rates (586.633kg/cm²) when compared with flat sawn boards (1008.467kg/cm²), Also 2cm thickness level achieved the lowest rate (747.367kg/cm²) when compared with other two levels 4cm (812.650 kg/cm²) and 6cm (837.633kg/cm²) of thickness. But, there were no any significant effects of wood density on the studied factors. E. camaldulensis in Kurdistan Region of Iraq has potential for traditional uses and by itself it can be harvested by applying suitable techniques at plantation areas, in saw mills and drying for utilization.
Downloads
Article Details
Section
This work is licensed under a Creative Commons Attribution 4.0 International License.
Authors who publish with this journal agree to the following terms:
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License [CC BY-NC-SA 4.0] that allows others to share the work with an acknowledgment of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work, with an acknowledgment of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online.