Comparative Study Among Direct Design Method, Equivalent Frame Method and Finite Element Method for Analysis of Slabs
Article Sidebar
Main Article Content
Abstract
Beam-column frame system and flat plate slab system are analysed by semi-empirical, Direct Design method (DDM) and approximate elastic method, Equivalent Frame method (FEM) and the results of both methods are compared with computer software based on Finite Element method (FEM), taking into account the effect of changing the beam and column stiffness and the panel length ratio, for 3, 4, and 5 equal span frames and three non-equal spans. The moment coefficients with respect to the maximum clear span moment are determined by the three methods for negative end moments at the face of support and mid span positive moment. These coefficients are constant in DDM, while in EFM are changed with changing the column and beam sizes. The results of EFM is more accurate than DDM, on the bases of results of EFM, new moment coefficients are suggested to use instead of DDM moment coefficients. In case of EFM calculation aren’t satisfactory for hand calculations the FEM is used by applying available computer software.
Downloads
Article Details
Section
This work is licensed under a Creative Commons Attribution 4.0 International License.
Authors who publish with this journal agree to the following terms:
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License [CC BY-NC-SA 4.0] that allows others to share the work with an acknowledgment of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work, with an acknowledgment of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online.